Ice Maker And Water Dispenser Not Working

No power at inlet into fridge side of valve when dispenser switch pressed.

Ice maker and water dispenser not working.

Common ice maker problems. Ice makers receive water through a small water supply line that runs from the refrigerator to a water pipe funnel or a water filter. The auger is driven by a motor mounted behind the bin with a set of drive forks on the gear box shaft. Usually one of the most crucial problems is the ge refrigerator dispenser not working after replacing the filter or ge refrigerator water dispenser not working but the ice maker is still working.

However a buyer needs to know about primary reasons or possibilities before purchasing this particular device from the market. The gear box turns very slowly but has lots of power to push the ice. The water inlet valve is an electrically controlled valve that opens to supply water to the dispenser and ice maker. If you find ice inside the ice mold it means your ice maker is receiving water and the problem likely isn t with the water supply.

Instead it s most likely a mechanical or electrical problem. Often the freezer could jam the chute area of the dispenser which creates misconceptions during. Dispenser board looks okay no obvious scorches. As a result the ice maker won t make ice.

To function properly it should deliver a flow of at least 20 psi. The valve requires at least 20 psi to function properly. The door switch turns off the ice and water dispenser when the refrigerator door is open. If the door switch does not have continuity when activated replace it.

Ice maker still functions as normal. Ice maker jammed sometimes a whirlpool ice maker is making ice cubes but it stuck inside at that time there will be griding noises but no ice cubes will pop out. If the water inlet valve is defective or if it has insufficient pressure it won t allow water to flow through. An ice maker can stop working for a variety of reasons.

Micro switch shows continuity when pressed open when off. If the door switch fails the dispenser will not turn on. The electronically controlled water inlet valve is used to supply water to the dispenser unit. Mains inlet side of water valve gets 240 volts when dispenser pressed and water flows through valve.

Water line malfunction or setting. The ice bucket auger is located in the ice bin and when the dispenser is activated will rotate to pull the ice forward to the outlet chute of the bin. The most common reasons for ice maker problems are. If someone notices carefully he will find out that the whirlpool ice maker is not working but the water dispenser is still running.